4 Point Jack Adapter for Axle, Transmission, Transfer case, Fuel Tank, Bumper - Floor Jack Base

Modular design allows easy assembly and reconfiguration for different objects to be held. The threaded supports use slotted bars that offer a lot of adjustment and plenty of strength. The threaded supports can still be offset from the base plate to support uneven loads. Spring snap buttons are used in the telescoping tube to prevent over extension and allow easy disassembly when pressed. Two base plates are offered for floor jacks or transmission jacks. A jam bolt on the base plate locks the main bar in place to prevent shifting while moving. Powder coated finish for ultimate durability.

-Easily converts most jacks to safely hold front and rear solid axles, fuel tanks, transfer cases, manual transmissions and bumpers
-Telescopic tubing lets you put the support points where they need to be
-Main bars adjust from 16-28" wide, are pinned for easy setup and provide solid load points
-Threaded bars adjust from 6-20" wide and provide fine adjustments to stabilize the load
-800 lbs. capacity at maximum extension
-Made in Oregon, USA

-New updated floor jack base plate - the fifth picture shows the updated base plate
Machined for newer floor jacks that bolt together, we still include a pin that presses into the base for older jacks with 1 3/16" pins. There are two styles of bolt on base plates, this will fit one of those, the other style will be added soon. This works for floor jacks that have a lip with the base removed. To check your jack, remove the base and look at the jack, if there is a lip sticking up your good, if the jack is flat then it won't work yet.

YouTube demo video (copy and paste)
Jack Adapter - Axle demonstration for Floor Jacks - https://www.youtube.com/watch?v=sntkympeXng