Armor AR350 Low Gloss Wet Look Sealer for Concrete and

Armor AR350 Low Gloss Wet Look Sealer for Concrete and Concrete Pavers (AR3505GAL)
- Armor AR350 is available in (3) formulations: 700 VOC, 350 VOC, and 50 VOC. Please see the VOC information in the listing before selecting your choice.
- Will enhance dull and faded surfaces with a low gloss wet look. It will darken the surface to make it look wet, and protect it with a durable, non-yellowing surface film.
- Will reduce damage caused by surface abrasion, road salts, water absorption, and exposure to the elements.
- UV resistant, non-yellowing, breathable. It won't trap moisture below the surface and will allow the substrate to properly breathe.
- Can last for up to 1-3 years before the need to recoat.
- Professional grade, made with high quality, non-recycled US manufactured resins.
- Easy to apply with a roller or sprayer to concrete and concrete pavers. Can be applied to unseaeled surfaces, and surfaces previously sealed with a solvent based acrylic sealer.
The Armor AR350 is a true wet look sealer. The Armor AR350 penetrates deep into the surface where it chemically bonds to the pores of the concrete and pavers, creating a long lasting, non-yellowing, breathable finish that enhances dull or faded surfaces by creating a darkened wet look, and low gloss finish. For a high gloss finish, consider the Armor AR500. Uses: The Armor AR350 is a fantastic sealer for poured concrete, stamped concrete, aggregate concrete, and concrete paver surfaces. It can be applied to unsealed surfaces as well as surfaces previously sealed with a solvent based acrylic. Do not apply to red clay brick, slate, tile, flagstone, or other natural stone surfaces. For those surfaces consider the Armor WL550 or Armor SX5000. Coverage: One gallon of the Armor AR350 will cover up to 200 square feet per coat. Two coats are recommended to achieve the maximum life and performance benefits. Coverage can vary depending on the porosity of substrate and the application method. How to Apply: First, make sure that the surface is clean and free of any contaminants that could prevent proper penetration or adhesion. If the surface was wet, allow at least 24 hours to dry. In the late afternoon or evening, when the surface has had time to cool down from exposure to the sun, apply the first coat using a 3/8" nap roller or solvent-resistant HVLP sprayer. Wait 24 hours and repeat with a second coat. Allow the surface 48 to dry before introducing it to water, foot, or vehicle traffic.

Country	USA
Brand	Foundation Armor
Manufacturer	Foundation Armor
Binding	Misc.
ItemPartNumber	AR350
Model	AR350 - 5 GAL - 700 VOC
Color	Clear
Size	5 Gallon Pail
UnitCount	1
UPCs	856994005015
EANs	0856994005015
ReleaseDate	0000-00-00

Armor AR350 Low Gloss Wet Look Sealer for Concrete and Concrete Pavers (AR3505GAL)

You might also like...