AIMILAR 36V Battery Indicator - 36 Volt LED Battery Gauge Meter for EZGO Golf Cart Trojan Batteries
Sold Out / Out of Stock
This item may be available in a different size, colour, scent, version or platform:
AIMILAR 36V Battery Indicator - 36 Volt LED Battery Gauge Meter for EZGO Golf Cart Trojan Batteries
✔️36 Volt LED Battery Indicator Meter Gauge for EZGO Golf Cart / Trojan Batteries only.
✔️Make sure you con-nect the wires going to the battery to the first and last positive and negative battery terminals in the series and not just one battery. Please reference the wiring diagram.
✔️Once battery was fully charged, meter will cycle through for continuous 6 minutes then stay "full" position.
✔️Only one LED bar lights up at the appropriate position.
LED Battery Indicator Gauge Meter for EZGO Golf Cart / Trojan Batteries Only
Notice: - Make sure your "C" terminal is either connected to the Battery "+" or a Key switch, Othersise, Meter will scan from full to empty then shuts off. - This battery indicator works on EZGO Golf Cart / Trojon Batteries only. - Only one LED bar lights up at the appropriate position. - Once battery was fully charged, meter will cycle through for continuous 6 minutes then stay "full" position.
Specifications: - The batteries voltage is displayed using a 10 segment LED bar graph(1 Red, 2 Yellow and 7 Green LEDs) display from full to empty. - The second LED from the left flashes as a warning that the batteries voltage has been discharged to 80% of their capacity. - At a 90% battery discharge, the red and yellow LEDs will alternately flash to indicate a very low voltage capacity is remining. - It is strongly recommended to recharge the batteries when you get to the 3rd Yellow LED, this is a safety precaution to avoid dead batteries. - Operating and Storage Temperature: -20℃ to 85℃. - Accuracy: +/- 0.5 percent. - Net Weight: 21g / 0.8oz.
Troubleshooting Tips 1, Meter cannot move to fully charged. This happens when battery was fully charged but the battery voltage cannot reach to preset fully charged voltage of meter, just disconnect the meter from power and reconnect, meter will reset to full.
2, Meter scans from full to empty then shuts off: This occurs if your "C" terminal is not connected, make sure your "C" terminal is either connected to the battery + or a key switch.