BBR Tuning Vibration Motor Mounts (6mm)

BBR Tuning Vibration Motor Mounts (6mm)
- REDUCE ENGINE VIBRATION: The BBR Tuning 2-Stroke Vibration Motor Mount Kit is designed to minimize engine vibration that's transferred to your bicycles frame. These vibration isolators install between your engines mount and frame and are constructed of a hard rubber that dampens as much as 75-85% of engine vibrations.
- PREVENTS BROKEN STUDS: With proper installations these mounts prevent premature failure caused by hard vibrations and improperly installed engine mount studs. No more broken engine studs or needed to us difficult screw extractors because of installation error.
- EASY INSTALATION: Installation is a breeze, just remove your engines stock front and rear motor mount studs and replace them with the longer heavy duty ones provided with the kit. Slide on your front and rear rubber block, drop your engine into your frame and tighten up your motor mounts. It's that simple!
- UNIVERSAL FIT: These vibration motor mounts are designed to work with 48cc, 60cc, 66cc and 80cc 2 stroke gas powered motorized bicycle engine kits.
- PACKAGE INCLUDES: 2x BBR Tuning Vibration Motor Mount Blocks, 4x 4.5" M6X1.0 Motor Mount Screws, 4x Lock Nuts, 4x Washers, 4x Lock Washers
Don't be fooled by the low quality Chinese knock-offs! These are the real deal- JNM Motors vibration motor mounts. Proudly made in the USA with the highest grade rubber available.

The JNM Front and Back engine mount vibration reducer is designed to control the engine vibration to supporting structures or frames. These isolators increase operator comfort and protect other equipment components from premature failure due to vibration. When properly engineered, these types of mounts can prevent as much as 75-85 percent of the engine vibration from being transmitted.

Specification

Â Â 1 Front Support Â 2"x1"x1.5"
Â Â 1 Back Support Â 2"x1"x1.5"
Â Â 4 Motor Screw 4.5" M6X1.0
Â Â 4 Lock Nuts
Â Â 4 Washers
Â Â 4 Lock Washers

Made in the USA

Package includes
This kit includes front and back rubber completed mounts, four us standard M6x1.0, four washers and lock nuts.
Country USA
Brand Flying Horse
Manufacturer Flying Horse
ItemPartNumber JNM-VIRBMOUNT
UnitCount 1
ReleaseDate 0000-00-00

Country	USA
Brand	Flying Horse
Manufacturer	Flying Horse
ItemPartNumber	JNM-VIRBMOUNT
UnitCount	1
ReleaseDate	0000-00-00

BBR Tuning Vibration Motor Mounts (6mm)

You might also like...