Step 1
Thoroughly clean the area where the pieces are to be applied with an rubbing alcohol to remove ALL residue and dirt. Let it dry.
Step 2
Without removing the red backing protective tape "dry-fit" ALL pieces, noting correct placement, joins and angles. Very Important Note: Â ALL pieces should be checked "dry-fit" before proceeding to Step 3. Immediately stop installation procedure and contact us even if one piece doesn't fit.
Step 3
Remove red tape from the back and apply pieces. It is not recommended to install letters when it's cold, let pieces be at least room temperature.
ATTENTION! SURFACE OF EACH LETTER IS COVERED WITH WHITE PAPER PROTECTIVE TAPE. IT SHOULD BE GENTLY REMOVED AFTER INSTALLATION. RED SIDE IS THE ADHESIVE SIDE (IT IS SOFT TO TOUCH SO YOU DON'T MAKE A MISTAKE).