BIQU Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer(Pack of 3pcs)

Product Description:
Features: Dimensions:60x50mm
Mounting holes:3.2mm diameter, for M3 screws
DCIN: "+" connect the power positive electrode: "-"connect the power negative, electrode(support "+ 12 v"or "+ 24 v" power supply, it is recommended to use + 24 v power supply)
Heatbed: connect to heatbed line(there are no positive or negative)
Connect the heatbed control port on the motherboard(there are no positive or negative)

Note:
1.When you connect power supply cable, you need to pay attention to distinguish the positive and negative polarity of the power supply,and do not reverse the connection of the cable to avoid burning the module and causing unnecessary losses
2.Module placement problem: when you use the module, do not put it in a place where the wires are dense. In this way, it helps to reduce the heating burden on the module and increase the safety
3.When the module is working: don't let the conductor to touch its bottom, it can prevent short circuit and burn out

Packge Included:
3 x Heated Bed Mosfet
3 x Connection cable for input signal
6x Cable for heat bed connect Wire
6x Cable for power