BibBoards SNAP & Lock for Event/Race Bibs Pinless Race/Event Bib Number Fasteners (Safety Pin Replacement) (Will Run for Wine)

BibBoards have a flat surface on the exposed side with your desired design. A second piece works by pushing part of a racer's shirt into a recess, providing a secure fit.

When the race is over, they pop off. BibBoards can be reused, and their special shape holds down a bib just as securely as safety pins, without the fuss.

BibBoards will not make a hole in your top.

Prepare The Racing Bib

If the bib does not have holes, make holes or slits 1 inch from the corners with a pointed object e.g., a pen tip or a knife.

To Secure Bib On A Racing Shirt Before Wearing It

• Position the bib over the racing shirt on a flat surface.
• Put the face stud through the bib hole and align with the back clip. Just push and click!

To Secure Bib On A Racing Shirt While Wearing It

• Starting with the top right hole in the bib, place the face stud through the hole/slit.
• Bring bib up to your shirt and place with the face stud on top (keep BibBoards away from nipples).
• Breath in to expand the material of shirt.
• Align back clip with each face stud and push until it clicks and locks.
• Check your BibBoards are secure by pulling on each face stud.

To Remove BibBoards

• Remove shirt and turn inside out.
• Pry the back clip up from the flat edge first.
• Repeat for other BibBoards