Description
CCNA 200-125 Step By Step Hands-on Labs: CCNA 200-125 Self-Study Lab Manual Practical Guide
This book contains CCNA Certification Exam 200-125 Step By Step Lab Exercises. The lab exercises can be performed either on the physical devices or on the simulators. However, arranging physical devices is certainly a difficult job. So we have designed this book for those self-learners who want to earn their CCNA certification and hands-on skills by self-study.
In this lab guide, we have used Cisco Packet Tracer simulator to demonstrate all the step by step lab exercises. The instructions are mentioned in such as details that a candidate having just the basic knowledge of computer can easily perform all the mentioned lab exercises without requiring any help from a trainer/instructor/institute.
This book consists of the following concepts and step by step lab exercises:
Lab Exercise 01: Downloading Cisco Packet Tracer
Lab Exercise 02: Creating a Topology in Cisco Packet Tracer
Lab Exercise 03: Getting Started with Cisco IOS
Lab Exercise 04: Basic Configuration of a Router
Lab Exercise 05: Breaking Router Password
Lab Exercise 06: Restore Cisco IOS from ROMMON Mode
Concept 01: Basics of Routing
Concept 02: The IP Routing Process – Step By Step
Concept 03: Classful vs Classless Routing Protocol
Lab Exercise 07: Configure Routing
Lab Exercise 08: Configuring RIP Routing
Lab Exercise 09: Configuring EIGRP Routing
Lab Exercise 10: Configuring OSPF Routing
Lab Exercise 11: Configuring OSPF Cost Metric
Lab Exercise 12: Configuring IPX Routing
Concept 04: Route Redistribution Basics
Lab Exercise 13: Route Redistribution between RIP and EIGRP
Lab Exercise 14: Route Redistribution between OSPF and RIP
Lab Exercise 15: Route Redistribution between OSPF and EIGRP
Lab Exercise 16: Implementing IPv6 Addressing
Lab Exercise 17: Configuring RIP for IPv6 (RIPng)
Lab Exercise 18: Configuring EIGRP for IPv6 (EIGRPv6)
Lab Exercise 19: Configuring DHCP on Cisco Router
Concept 05: Process of Building MAC Address Table
Lab Exercise 20: Enabling Remote Access
Lab Exercise 21: Configuring VLANs
Lab Exercise 22: Configuring Inter-VLAN Routing
Lab Exercise 23: Configuring Etherchannel
Lab Exercise 24: Configuring Port Security
Lab Exercise 25: Configuring Spanning-Tree Protocol
Lab Exercise 26: Configuring Spanning-Tree PortFast
Lab Exercise 27: Configuring Access Control Lists (ACLs)
Lab Exercise 28: Configuring Static and Dynamic NAT
Lab Exercise 29: Configuring Frame-Relay
Lab Exercise 30: Configuring WAN authentication
Lab Exercise 31: Configuring Redundancy using HSRP
Lab Exercise 32: Configure Syslog Server
