Calculs Iron on Hip Hop Patches Multi-Sized Embroidered

Calculs Iron on Hip Hop Patches Multi-Sized Embroidered Letters for Skateboarding Clothing Rock DIY 22 Pcs/Set
- ▶Iron-on patches are a great way to express your individuality - and they're also useful for hiding damaged or torn spots on your clothes and accessories. These patches can be widely used for shoes, coats, jeans, bags, suitcases, pillowcases and curtains. Common electric iron is available for applying in most conditions.
- ▶Position the heated iron over the patch and press down. Hold the iron there for about 15 seconds. Apply as much pressure as you can by pressing down firmly. For a completely secure patch, use a sewing machine or a needle and thread to secure the patch to the fabric. This greatly reduces the chances that the patch will fall off.
- ▶Don't wash the article more than necessary. Iron-on patches are meant to be permanent, but they do become loosened over time. Take care not to let the article get too dirty, since washing it may cause the patch to start coming off. If you do need to wash the item, hand wash it using cold water. Allow it to air dry.
- ▶Don't iron patches onto leather, silk or other delicate fabrics. Instead, sew it on. Fabrics like denim and cotton provide the best base for iron-on patches. Be very careful with polyester fabrics, since applying the high heat necessary for ironing on patches can burn the fabric or cause it to get discolored.
- ▶These patches are well-packed to prevent from dust and moisture. If you received a broken or a missing one or just dissatisfied with them, please return to Amazon and get your full-refund at once. Or find support by send us a message through Amazon or address calculs(at)outlook(dot)com!
General Using Guide for Calculs Heat Transfer Products (Iron on Patches and Transfer)



For household iron:

    Place the t-shirt or fabric on a hard, flat surface, and smooth out the shirt with the iron if the shirt happens to be wrinkly. The surface you're ironing on should be heat resistant (unlike an ironing board) and should be large enough to be able to iron the entire area of the transfer.

     Set your iron to the hottest setting but do not use steam. Steam can greatly hinder the transfer's ability to adhere to the fabric. Give the patterns heat and pressure evenly for 30 to 60 seconds. Iron the inside of the t-shirt for 15to 30 seconds with the same steps above.

     Check to make sure the edges of the transfer are fully attached before you move onto removing the backing paper. If the edges are not fully stuck to the fabric, continue to iron the edges of the transfer. Be sure to apply steady and even pressure as you iron so the complete image is fully attached.



Remember the key of a perfect transfer image are enough PRESSURE and uniform HEAT.

Ironing on hard surface like Formica or a wooden cutting board would be especially useful for doing iron on transfers because they are good at retaining heat.



And if you have a heat press machine, set the machine within 160 to 180 degrees and press down for 5 to 10 seconds.



Calculs says

You can find support via calculs@outlook.com anytime which will be answering each message within 12hours.

Country	USA
Binding	Office Product
Brand	Calculs
Color	Whole Set Embroidery (22pcs)
EAN	0666389194428
Label	Calculs
Manufacturer	Calculs
MPN	BT-supreme
PartNumber	BT-supreme
Publisher	Calculs
Studio	Calculs
ReleaseDate	0000-00-00

Calculs Iron on Hip Hop Patches Multi-Sized Embroidered Letters for Skateboarding Clothing Rock DIY 22 Pcs/Set

You might also like...