COMP Cams 623-16 Machined Steel Set of 16-7 Degree, 8mm,

COMP Cams 623-16 Machined Steel Set of 16-7 Degree, 8mm, Single Groove Race Locks
- Package Dimensions: 0.762 H x 7.62 L x 12.7 W (centimeters)
- Country of Origin : United States
- Package Weight: 0.1 pounds
- Fit type: Vehicle Specific
These single groove Machined Steel Street Locks with 7 degree lock angle and 8mm valve stem size are perfect locks for GM Gen III/LS1/LS2/LS6 applications. It is critically important to make sure valve locks match the valve size. There should always be a small gap between the two halves of the lock when they are properly positioned on the valve stem. If the two halves fit together without a gap, they are too large. If the locks fit tight to the stem and leave a gap between the middle of the lock and the O.D. of the stem, the locks are too small. Most people believe that the tang inside a valve lock holds the retainer and valve spring in place while the engine is running. This is not the case. The cross-section of material in the tang is not strong enough to withstand open spring loads of 1000 pounds. or more. The sole purpose of the tang is to temporarily locate the lock, retainer and spring relative to the valve until the taper of the retainer can nest around the outside surface of the lock. This creates a â€œcolletâ€ effect that binds the two together. The more spring force exerted on the retainer (as the valve opens), the more force applied by the â€œcolletâ€ effect to keep the retainer and lock in place.
Country USA
Brand Comp Cams
Manufacturer COMP Cams
Binding Automotive
ItemPartNumber 623-16
Model 623-16
Size Single Groove
UnitCount 1
UPCs 036584094210
EANs 0036584094210
ReleaseDate 2019-07-15

Country	USA
Brand	Comp Cams
Manufacturer	COMP Cams
Binding	Automotive
ItemPartNumber	623-16
Model	623-16
Size	Single Groove
UnitCount	1
UPCs	036584094210
EANs	0036584094210
ReleaseDate	2019-07-15

COMP Cams 623-16 Machined Steel Set of 16-7 Degree, 8mm, Single Groove Race Locks

You might also like...