DROK Mini Boost Voltage Converter DC 3.2-13V to DC ±15V

DROK Mini Boost Voltage Converter DC 3.2-13V to DC ±15V Positive Negative Dual Output Power Regulator Module 100mA Step Up Volts Transformer Board
- DROK micro voltage converter with low voltage input range DC 3.2-13V, positive and negative dual output voltage is ±15V, rated output current is 100mA.
- APPLICATION: the step-up regulator module can be applied to meet the needs to power for general op amp circuit, also can be applied to low ripple noise circuit.
- SMALL MODULE HIGH EFFICIENCY: DROK boost converter is with mini dimension 23.5x14.0x6.5mm; the small module conversion rate can be up to 82%.
- SIP or DIP PACKAGE: the volt transformer module not only support single in-line(SIP) package, but also support dual inline-pin package (DIP), which will be convenient for your use.
- NOTE: please note that the module doesn't support short circuit protective function, please pay attention before wiring; it can get better performance if positive and negative output current are greater than 20mA.
Parameters:
Input Voltage Range: 3.2~13VDC
Output Voltage: Â±15VDC
Output Voltage Precision: Â±1.5%(output positive +Vo, 100% load); Â±5%(output negative -Vo, 100% load)
Linear Adjustment Rate: Â±0.5%(output positive +Vo, 100% load); Â±1.5%(output negative -Vo, 100% load)
Load Adjustment Rate: Â±1%(output positive +Vo, 100% load); Â±3%(output negative -Vo, 100% load)
Rated Output Current: 100mAÂ
Efficiency: 82%
Ripple Noise: 60~120mV (input voltage 5V, full load 3W output)
Working Temperature: -40~+85â„ƒ (if more than 50 â„ƒ, needs derating 0.05W / â„ƒ)

Terminal Function:
VIN: 3.2V~Vinmax DC voltage input
GND: Input and output common ground
+Vo: Output positive
-Vo: Output negative
NC: Vacant port, no electrical connection
EN: Module Enable (when VEN <0.8V, the module does not work; when 1.4V Note: when VEN <0.8V, the circuit structure is limited, at this time, + Vo still voltage output about VIN; and -Vo no voltage output.

Note:Â
1. Please note that the module doesn't support short circuit protective function, please pay attention before wiring.
2. It can get better performance if positive and negative output current are greater than 20mA.
3. + Vo is forbidden with no-load; when the -Vo load is too heavy, + Vo load is too light, it is recommended to increase dummy load resistance at the + Vo and ground.
4. C1/C2/C5/C6/C7/C8 adopts ceramic capacitors can get better overall performance; Â LM78xx/LM79xx three-terminal regulator chip can be replaced with the same function chip.
5. EN is enable pin, for general application, the pin can be vacated, the module default normal output.

Package Including:
1x Mini Boost Voltage Converter
Country USA
Brand DROK
Manufacturer DROK
ItemPartNumber 2001708004
Model 2001708004
ReleaseDate 0000-00-00

Country	USA
Brand	DROK
Manufacturer	DROK
ItemPartNumber	2001708004
Model	2001708004
ReleaseDate	0000-00-00

DROK Mini Boost Voltage Converter DC 3.2-13V to DC ±15V Positive Negative Dual Output Power Regulator Module 100mA Step Up Volts Transformer Board

You might also like...