XCSOURCE Drill Charging Station | Drill Storage | Wall Mounted | Power Tool Storage | Power Drill Toolbox Screwdriver Cordless Drill Organizer - Tool, Parts Craft Organizer Wooden

Features:
♣ 2 sufficient storage space for placing tools and parts, and 5 hanging slots for electric drills
♣ The surface and edges of the board are polished,smooth and will not scratch your fingers
♣ 48 screws for multi-dimensional connection of product parts
♣ Our products are made of high-quality hard wood and surface treatment technology, which makes the product moisture-proof, anti-erosion, strong and durable

Product parts and installation steps
A x 4 ; B x 4 ; C x 1 ; D x 1; E x 1 ; F x 1 ; G x 1 ; H x 2; I x 40 ; J x 4 ; K x 4

Step 1
Find A and B plates, the B plates are placed horizontally, the A plates are placed vertically, and the two plates are locked with I. In the same way, four A plates and four B plates are assembled
Step 2
Take out C board,The two screw holes above the A board are aligned with the two screw holes of the C board and tightened with I
Step 3
Align back of above installed module with the 6 holes in the lower part of the D plate and tighten with I
Step 4
Place E-plate horizontally and align two screw holes in middle of the D-plate and tighten with I. Assembled into new modules
Step 5
Take out G plate and F plate, connect H plate to the bottom of G plate (without the side of the wire slot).Connect the H plate to the bottom of the F plate with I, and keep the two H plates in opposite directions.
Step 6
Install G and F plates on left and right sides of the new module respectively, and tighten them with I
Step 7
Hold D plate against wall, align 4 holes of D board and use J to drive into the wall. Then use K through 4 holes of the D board

Package includes:
1.3 types of screws

48 in total

2.15 planks