uxcell M6 x 1mm x 2D 304 Stainless Steel Helicoil Wire Thread Inserts 20pcs
Specifications:
Thread inserts material: stainless steel
Thread tap and the drill material: HSS
Wrench: surface electrophoresis
Wrench size: 55 * 20mm/2.17 * 0.79inch
Thread specification: M6
How to use:
1.Clear the damaged threads with a standard drill. (to repair a spark plug thread no pre-drilling is necessary if using the special spark plug tap), please pay attention that for fluteless taps bigger holes are required.
2.Checking - check that the thread and pitch of the tap and the bolt match.
3.Tapping - use the special taps for cutting the holding thread into the cleared hole (recommended to use a suitable cutting oil).
4.Install the insert - place insert on installation tool and position the adjustable ring so that the insert tang is centered in the tang slot. Wind the insert in with a light downward pressure until a half turn below the surface. Don't work against the thread direction as the tang could break.
5.Tang removal - After finishing lift the installation tool and use the tang break tool to remove the tang. For bigger sizes and spark plug taps use long nose pliers to remove the tang. Due to the narrow and exact tolerances the new thread normally is stronger than the original ones.
Package included:
25 x Thread inserts
1 x Lug breaking tool
1 x Installation tool
1 x wrench
1 x Thread tap
1 x Drill bit
Country | USA |
Brand | EWONICE |
Manufacturer | EWONICE |
ItemPartNumber | EL011 |
Model | 13 |
Size | M6 |
UPCs | 606794269922 |
EANs | 0606794269922 |
ReleaseDate | 0000-00-00 |