Faucet Knockout for Cast-In-Place Concrete Countertops - Z

Faucet Knockout for Cast-In-Place Concrete Countertops - Z Counterform
- Friction fit silicone faucet knockout for cast-in-place concrete countertops.
- This knockout will create a 1-3/8" hole which will work with most standard faucets. It will also create a 2-1/2" pocket that is 1" beneath the surface to fasten hardware in. This will accept most faucets and spouts.
- Must be used with 1/2" substrate and our standard 2-1/4" Z Counterforms.
- To install, use a 2-5/8" hole saw. Push the knockout up through the hole from the underside of the cement board until the 3rd ring hits the bottom of the cement board. Full instructions below...
To install, use a 2-5/8" hole saw. Push the knockout up through the hole from the underside of the cement board until the 3rd ring hits the bottom of the cement board. Check to make sure the top of the knockout is flush with the top of the forms. For most applications we normally like to split the difference between the sink opening and the backwall so that you have the most concrete possible around the faucet. If you have a deeper countertop or smaller sink, please check to make sure that the faucet is lined up properly over the sink. WARNING: some of the newer faucets require larger than 1-3/8" hole. Please check your facucet. If you need a larger hole, you can wrap the top of the knockout in electrical tape to increase the diameter.
Country USA
Brand Z Counterform
Manufacturer Concrete Countertop Solutions
Binding Misc.
UPCs 733074197863
EANs 0733074197863
ReleaseDate 0000-00-00

Country	USA
Brand	Z Counterform
Manufacturer	Concrete Countertop Solutions
Binding	Misc.
UPCs	733074197863
EANs	0733074197863
ReleaseDate	0000-00-00

Faucet Knockout for Cast-In-Place Concrete Countertops - Z Counterform

You might also like...