Fibre Glast PVA Release Film - 1 Gallon - Sprays On - Easy

Fibre Glast PVA Release Film - 1 Gallon - Sprays On - Easy Release for Molds

PVA, or polyvinyl alcohol, should be used with our #1016 Partall Wax for the easy release of parts from a mold. Wax should be applied to the mold, 3-4 layers thick, and buffed to a high gloss. Once the final layer of wax has dried, PVA should be applied with the following considerations: PVA can be brushed on, but for best results, apply with a spray gun, 12-18 inches away from substrate. Generally, apply in three layers: the first, a thin mist, allowing 10-15 minutes to dry completely. Then apply two heavier flow coats, allowing each to dry completely (30-45 minutes each). PVA should form a smooth, glossy surface that will not shrink or pull away from corners or curved surfaces. It may be applied over polyester repairs, or gel coat, as a surface layer for airless tack-free cure. As a dry film, PVA is resistant to the solvents in a resin system, but is water soluble. PLEASE NOTE: It should not be used with resin or substrate that contains-or produces-water during cure. One gallon covers approximately 400 square feet.
Country USA
EAN 0802390004466
Feature Easy Spray-On - Easy Release for Molds
Label Fibre Glast
Manufacturer Fibre Glast
MPN 13-B
PartNumber 13-B
Publisher Fibre Glast
Studio Fibre Glast
ReleaseDate 0000-00-00

Country	USA
EAN	0802390004466
Feature	Easy Spray-On - Easy Release for Molds
Label	Fibre Glast
Manufacturer	Fibre Glast
MPN	13-B
PartNumber	13-B
Publisher	Fibre Glast
Studio	Fibre Glast
ReleaseDate	0000-00-00

Fibre Glast PVA Release Film - 1 Gallon - Sprays On - Easy Release for Molds