GATEXPERT Photocell Sensor for Gate Opener Universal Outdoor Infrared Beam Sensor Sliding Gate Opener Accessory 24V 1 Pair(transmitter and receiver)
- INTERNAl -- Single beam active intruder infrared detector with buit-in AGC control circuit.Can effectively prevent sunlight.
- PACKAGE -- There are no wires in the package and you need to prepare it by yourself.
- MATERIAL DESIGN -- Totally-sealed rainproof and mothproof design.
- APPLICABILITY -- Can be widely used for access control system,parking lot,defence wall,door and window,balcony,garage,passage and other places.
- NOTE -- The installation height should be lower than people，please also consider the height of the child for security.
GATEXPERT
GATEXPERT is a professional manufacturer and supplier of gate openers, our products are sold all over the world.
We are specialized in researching intelligent control system and driving source solution for all kinds of gates.
We try our best to provide better service for our customers, and we are always on the way to improve our products.
We would appreciate it if you could give us great suggestions which can make us better, and we are happy to accept it and improve our products and service.
Technical Parameter:
Power supply: DC 10.5V-24V/0.5A
Maxium current: TX:15maMAX RX:30maMAX
Optical source: Infrared Pulse
Infrared Wave length: 940nm
Infrared transmission frequency: 1.92KHz
Response speed: 50ms
Alarm output time: ≥1 Second
Detection mode: Block off the infrared beam
Infrared angle: < ±10°
Infrared distance: ≤20m
Relay contact capacity: ACã€DC30Vã€0.5Amax
Working environment: Temperature: -25℃~+55℃ Humidity:RH95%
Product dimension: 76x48.2x30(mm)
Note:
1.The optimal installation height should be higher than 20m.
2.The product should be vertical when install and make sure the transmitter and receiver be at the same level.
3.Since the transmitting power of this product is large,the signal will be very strong if the transimitter is too close with the reciever,so please make the distance at least 1 meter btween the transmitter and receiver, then try again.
4.When the installation distance is very close, remove the spectral lens to enhance the sensitivity.
Package includes:
1*Photocell Sensor(one transmitter and one receiver)
1*Mounting Accessories
