Gizmo Dorks PEI Sheet 3D Printer Build Surface 235mm x 235mm (9.3" x 9.3") with Preapplied Laminated 3M 468MP Adhesive for Creality Ender 3 or CR 20 | Made in The USA

Installation

The polyetherimide sheet comes with 3M 468MP adhesive already laminated to the PEI. Apply the PEI with slight pressure and at an angle to prevent and minimize air bubbles. Once applied set the print bed to 60C and apply pressure evenly across the PEI in a sweeping fashion to firmly set the adhesive. Please use a towel to avoid getting burned. Level the bed and set the height of the nozzle before printing.

If PEI is installed to the top surface of a bed sandwich (a build plate with multiple layers), it is recommended to install PEI on top of borosilicate glass.

Use

Heat the bed to the desired temperatures for printing (60 C for PLA and 100 C for ABS). Depending on how thick your bed sandwich is, your set temperature may not be your surface PEI temperature.

When the print is completed, let the bed cool, and the part will be easy to release from the PEI surface. Parts are easier to remove if released before the bed becomes completely cold.

Leveling the bed is very, very important when using PEI. You want the first layer to be close enough to be squished a little. PETG is an exception and doesn't like squished layers, in which case a Z gap should be used.

Maintenance

Clean in between prints with isopropyl alcohol. Acetone can be used instead of isopropyl alcohol, but the bed must be cold if acetone is used. Optionally, light sanding with 600-1000 grit sand paper can be done after lots of printing to give the PEI sheet more life.

Compatibility

Creality Ender 3 / Creality CR 20 / and more!

The Creality Ender 3 and the CR 20 have build volumes of 220 x 220mm with a plate size of 235 x 235mm.

Dimensions

235mm x 235mm (9.25 x 9.25 inches)
PEI thickness: 0.56mm (0.022 inches)
3M 468MP adhesive thickness: 0.13mm (0.005 inches)