Holybro 500mW Telemetry Radio Set (V3 for Pixhawk4) (915MHz)
Sold Out / Out of Stock
Please be aware orders placed now may not arrive in time for Christmas, please check delivery times.
This item may be available in a different size, colour, scent, version or platform:
Holybro 500mW Telemetry Radio Set (V3 for Pixhawk4) (915MHz)
Transparent, full-duplex serial com-link
Open-source firmware
Holybro 500mW Telemetry Radio Set (V3 for Pixhawk4) 915MHz
Features: Transparent, full-duplex serial com-link Hardware flow control Open-source firmware Frequency Hopping Spread Spectrum (FHSS) Protocol Communicates with any 3DR/SiK telemetry radio Pixhawk not required - Easily adaptable to your other projects.
Specifications: Radio Frequency: 915MHz Output Power: 20 levels, up to 500mW (27dBm) Size: 53x26x11mm (no antenna) Weight: 14g (no antenna) Rx Sensitivity: -117 dBm Operating range: -40 to 85°C Power Input: 5VDC (via micro-USB or JST-GH) Current, Tx: 500mA @ 27dBm Current, Rx: 25mA Serial (UART) Level: 3.3V Windows USB Device Driver: FT230X Chip Antenna Connector: RP-SMA
Status LEDs: Green, blinking: searching for signal Green, steady: link established Red, blinking: transmitting Red, steady: firmware updating No Light: No Power
Use Mission Planner, or any Terminal Emulator (AT/RT command set), to change available settings: output power, duty cycle, frequency range, number of channels, listen before Tx, error correction, opportunistic resend, link ID, air speed, MAVLink framing, etc.
What's in the box? 2x Radio Modules (interchangeable) 2x RP-SMA Monopole Antennas 2x 90° RP-SMA Antenna Connectors Micro-USB cable Android OTG cable JST-GH 6P to 6P cable for 2nd generation and later Pixhawk MLX 6P to JST-GH 6P cable for original Pixhawk 2x Adhesive pads