Oneway 3207 Easy-Core 20" Base Set

Oneway 3207 Easy-Core 20" Base Set
- Oneway Model #3207
- For lathes with 20" swing (Oneway 2036, 2016 or similar)
- The Base Set needed is determined by the swing of the lathe
- Any size lathe from 14" to 26" swing (with flat bedways) can be accommodated with the Easy-Core Coring System
- Clamp Block is sold separately. A Clamp Block is needed with the Base Unit. To determine the size of the Clamp Block needed, measure the distance between the bedways. This GAP determines the Clamp Block required
Why use a coring system for turning bowls? Imagine taking a premium quality turning blank and not only turning it faster, but also with less effort, less wear on your tools, less waste to clean up - and winding up with several bowls instead of just one! How Does the Easy-Core Work? - A heavy duty steel base plate attaches to the bed of the lathe. Two supports, one for the support finger and one for the cutter blade, are attached to the base plate. The support finger and cutter blade fit into these supports. The position of the support is determined by the size of the blank being cored and the wall thickness desired. A tool handle is attached to the cutter blade and is used to introduce the cutter to the wood. This system has been designed in such a way that the tailstock can be used while coring. Using the tailstock in any wood turning operation greatly increases the safety factor. When the entry cut is made, the support finger is positioned at the face of the bowl supporting the cutter blade. With the cutter is on a fixed arc and it becomes a simple matter of deepening the cut by exerting pressure with the handle. After progressing 2 - 3 inches into the groove, the cutter is removed and the lathe stopped to re-position the support finger by introducing it into the groove. This procedure is repeated until the knife reaches maximum depth. The core is then removed by tapping the edges or a bit of easy prying. Cores produced will be symmetrical and have a smooth surface. Easy-Core Base Set - The unit needed is determined by the swing of the lathe. The swing is the distance from the middle of the spindle to the bed multiplied by two. Any size lathe from 16" to 26" swing and flat bedways can be accommodated with the Easy-Core Coring System. Base Set includes: the Base; Front & Rear Post; Short Tool Handle; Screws & Washers; and an Instructional DVD. Note: Required Easy-Core Knife Sets and Clamp Block Sets sold seperately.
Country USA
Brand Oneway
Manufacturer Oneway
Binding Misc.
ItemPartNumber 3207
UPCs 883111032074
EANs 0883111032074
ReleaseDate 0000-00-00

Country	USA
Brand	Oneway
Manufacturer	Oneway
Binding	Misc.
ItemPartNumber	3207
UPCs	883111032074
EANs	0883111032074
ReleaseDate	0000-00-00

Oneway 3207 Easy-Core 20" Base Set

You might also like...