Raven Eye Custom Bedding Pillar Pack, 1/2" and 7/16" diameters
Sold Out / Out of Stock
Raven Eye Custom Bedding Pillar Pack, 1/2" and 7/16" diameters
Contains two pillars for multiple stocks, or for front and rear bedding
Made from bar stock aluminum, clear anodized
Overall length of 1.200" for 1/2" pillar and 0.800" for 7/16" pillar
Roughened finish to increase adhesion of bedding epoxy
For use with stock accurizing, a must for benchrest, and the only way to go SUB MOA
The inside diameter of the pillar (hole) is = 0.260", which can accommodate up to a #14 bolt (1/4") or a M7 metric bolt freely. The outside diameter is irregular to increase adhesion. The 1/2 pillar has a maximum diameter at 0.480", so it can fit freely in a 1/2" (0.500") diameter hole, or tightly in the same hole with bedding epoxy applied. The 7/16 pillar has a maximum diameter of 0.430" so it can fit freely in a 7/16" (0.4375") diameter hole, or tightly in the same hole with bedding epoxy applied. All our pillars are CNC machined from aluminum for the highest precision. The pillar must be cut to length (with the exception of the specific Ruger 10/22 pillar), and are long enough for all installations. In many cases, this will result in enough material for more than one installed pillar. The roughened finish on the outside of the pillar increases the surface area the bedding epoxy can bond to, providing a more secure installation. Correctly pillar bedding a rifle will improve its accuracy.