Snaps are compliant with CPSC CPSIA standards regarding lead content in children's products.
NOT COMPATIBLE WITH THE KAM PLIERS SOLD ON AMAZON (which only work with plastic snaps). Can be installed with KAM table-top professional presses with corresponding dies or KAMsnaps KX professional handheld press.
Approx 7/16" (10mm) diameter. Cap prongs are approx 3.5mm long, sufficient for thinner sewing fabrics but not intended for use with thick or dense fabrics.
Thin or stretchy fabric like knits and jersey must be reinforced with sturdier material around the area of snaps to avoid ripping (this is true with all snaps).
NOT COMPATIBLE WITH THE KAM PLIERS SOLD ON AMAZON (which only work with plastic snaps). For best results, use with KAMsnaps KX professional handheld press or KAM DK93 / DK98 table-top professional snap press to get a perfectly installed snap every single time. Old-fashion hammer method may not yield consistent results.
No-sew alternative to buttons. Snaps are commonly used on toddler onesies, children's clothing, pacifier clip holders, bibs, and more. Shorter prong length ideal for thinner fabric. NOT recommended for heavy or thick material. IMPORTANT: Thin or stretchy fabric like knits and jersey must be reinforced with sturdier material around the area of snaps to avoid ripping (this is true with all snaps).
KAMsnaps is a one of the most trusted and recognized name in snaps. These snaps have been tested to meet CPSIA regulations for lead content in children's products. Not all snaps out there are made the same so beware of cheap imitations that may look similar but which will not perform.
IMPORTANT INSTALLATION NOTE: There is a right way to install the female side and a wrong way. Please refer to the 3rd thumbnail photo which illustrates this. The center ring has notches on one side, while the center ring on the other side is smooth. It is the notched side that snaps into the male.