SparkFun (PID 09947 USB Host Shield

SparkFun (PID 09947 USB Host Shield
- MAX3421E USB Peripheral/Host Controller with SPI Interface
- Arduino shield format
- A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.
- The Host Shield takes its power from the ‘Vin’ pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield
- All SPI signals are sent through a hex converter to step them down to 3.3V.
This new version corrects the pin out for the GPX and RESET pins. The SparkFun USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!
A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino's hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.
The Host Shield takes its power from the 'Vin' pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.
Country USA
Brand SparkFun
Manufacturer SparkFun
Binding Electronics
ItemPartNumber LYSB01MZ977T4-ELECTRNCS
Model LYSB01MZ977T4-ELECTRNCS
UPCs 717520030782
EANs 0717520030782
ReleaseDate 0000-00-00

Country	USA
Brand	SparkFun
Manufacturer	SparkFun
Binding	Electronics
ItemPartNumber	LYSB01MZ977T4-ELECTRNCS
Model	LYSB01MZ977T4-ELECTRNCS
UPCs	717520030782
EANs	0717520030782
ReleaseDate	0000-00-00

SparkFun (PID 09947 USB Host Shield

You might also like...