Step block hold-down set

Step block hold-down set
- Small size version of hold-down sets used on full-size mills
- Stepped angle blocks and matching stepped clamps engage each for quick height adjustment
- Six pairs of threaded studs from 1" to 3.5" included
- Matching concave/convex nuts and washers hold clamps that are not parallel to the table
- Extra unanodized block included to be cut into smaller blocks for special jobs
This is a scaled-down version of the step block sets commonly used with full-size mills. The angled blocks have an extruded step pattern up the angled side. Clamps have the corresponding step pattern in the end. To clamp a part you engage the steps on the clamp with the steps on the block at the proper height and then pull them down by tightening a nut on a threaded rod held in a T-nut in the mill table T-slot. The special nut has a convex bottom surface, and it mates with a nut that has a concaved top surface. This allows full contact of the hold-down nut even on clamps that are not parallel to the table. The set includes two clamps, two anodized angle blocks (plus one un-anodized block to be cut to size as needed), two nut/washer sets, 4 short and 4 long T-nuts and 6 pairs of threaded rods ranging from 1" to 3.5" long. For hard-to-hold castings and parts requiring additional clamping pressure it is recommended that you use additional clamps rather than overtightening a few clamps. Though it can be used on other tools, the T-nuts are designed to fit Sherline lathe and mill table T-slots.
Country USA
Brand Sherline
Manufacturer Sherline Products Inc.
Binding Misc.
ItemPartNumber 1
ReleaseDate 0000-00-00

Country	USA
Brand	Sherline
Manufacturer	Sherline Products Inc.
Binding	Misc.
ItemPartNumber	1
ReleaseDate	0000-00-00

Step block hold-down set

You might also like...