Tilta Nucleus-M: Wireless Lens Control System

Tilta Nucleus-M: Wireless Lens Control System | WLC-T03 (WLC-T03-K1)
- [FOCUS IRIS ZOOM] via the FIZ or Left and Right Hand Grips
- [PRECISE FOCUS] via Marking Discs, A-B Limits, and Electronic Focus Marking
- [NO MDR NEEDED] Wirelessly Control the Motors Up to 1000 Feet
- [RUN STOP CAPABLE] via the REC Button on the FIZ/Hand Grips and Optional Run Stop Cables
- [COMPATIBLE] with Most Cinema Lenses via the Motor's 0.8 Gear Pitch or Included Gear Rings
The Nucleus-M is a revolutionary and highly customizable 3-channel wireless lens control system. It allows you to have full control of focus, iris, and zoom on either the FIZ hand unit or between the two wireless hand grips. You can even split control of the channels between the hand unit and wireless hand grips as you see fit with the push of a button. The wireless range of both the hand unit and hand grips is 1,000 feet and with the planned upcoming transmission upgrade, the range can reach up to 1 miles! This makes it ideal for drone or car-mounted shots. The hand grips can be attached to the included rosette mounts for handheld operation and can also be attached to top bar-based gimbals with the included Nucleus-M Hand Grip to Gimbal Adapters or to ring-based gimbals with the optional Nucleus-M Hand Grip Universal Gimbal Ring Adapters. Each motor has its own built-in motor drive that communicates directly with the hand unit and hand grips. This negates the need to mount a separate MDR to your rig, allowing for a more compact camera setup and a quicker setup time. Simply set the motors and hand unit/hand grips to the same channel and you will have full control. The motors allow for automatic calibration of the lens as well as manual calibration if you are using lenses that don?t have hard end stops at close focus and infinity. The motors are designed to clamp onto 19mm or 15mm rods (with the included rod bushings). This clamp-on design allows you to easily attach and detach the motors without needing to remove any other accessory from your setup. Every motor has a 0.8 mod, 35 tooth, 32 pitch gear attached, which is the standard gear size for cinema lenses. To power the motors, only one power port on your camera rig needs to be used. Simply plug the P-tap power cable into one of the motors and then daisy chain power to the rest of the motors with the short 7-pin to 7-pin cables.
Country USA
Brand Tilta
Manufacturer Tilta
Binding Electronics
ItemPartNumber WLC-T03-K1
Model WLC-T03-K1
Color Black
UPCs 631384550210
EANs 0631384550210
ReleaseDate 0000-00-00

Country	USA
Brand	Tilta
Manufacturer	Tilta
Binding	Electronics
ItemPartNumber	WLC-T03-K1
Model	WLC-T03-K1
Color	Black
UPCs	631384550210
EANs	0631384550210
ReleaseDate	0000-00-00

Tilta Nucleus-M: Wireless Lens Control System | WLC-T03 (WLC-T03-K1)

You might also like...