WINGONEER 5Pcs SW-420 NC Type Vibration Sensor Module Vibration Switch for Arduino Smart Car
Sold Out / Out of Stock
WINGONEER 5Pcs SW-420 NC Type Vibration Sensor Module Vibration Switch for Arduino Smart Car
WINGONEER® trademark Reg.NO:4747611
Description: If the module does not vibrate- the vibration switch was closed on state- output of low output- the green indicator light. The product vibrates- vibration switch momentary disconnect- output is driven high- the green light does not shine. The output can be directly connected with the microcontroller- which to detect high and low level- so as to detect whether the environment exist vibration- play a role in the alarm.
Feature: Using SW-420 normally closed type vibration sensor Comparator output- clean signal- good waveform- strong driving ability- >15mA Working voltage 3.3V ~ 5V Output format: digital switching output (0 and 1) Using a wide voltage LM393 comparator With bolt holes for easy installation Small PCB size: 3.2 x 1.4cm
Note: Power direction cannot be reversed- otherwise it is possible to burn the chip Signal LED light is output Low- signal LED OFF output is High The output level close to the input voltage