WitBot TMC2130 V1.1 SPI Motor Driver Silent Board with Heat

WitBot TMC2130 V1.1 SPI Motor Driver Silent Board with Heat Sink and A Aet Wire for 3D Printer (Pack of 4)
- TMC2130-V1.1 is a new module that is optimized and upgraded to solve the problem that older drivers cannot choose to use the SPI working mode
- SPI working mode of TMC2130-v1.1 can directly select driver current, driver subdivision and other parameters through firmware.
- Using sequexternal sequencers that reduce the workload of the chip and effectively avoid problems such as running deviation, losting step and fault caused by the overload of the chip.
- The TMC2130 driver is a 256-segment, which must be paired with a heat sink and a fan for heat dissipation.
- Good to work with ramps 1.6 ,mks gen v1.4,tango v1.0 and so on.
This module is similar to TMC2100, which will generate a lot of heat energy when it working.
Therefore, heat sink and heat dissipation fan must be added to cool it down during the use, which reduce the occurrence of losting steps and running deviation
Parameter:
Working Mode: Dir Step SPI
Â MicroPlyer:1/256
MicroPlyer Mode: Up to 256 Driver
Current: Up to 2A Input
Â Voltage:4.75-46V DC Logical Voltage:3-5V
Decibel:<10dB
RDSon: â‰¥0.5Î©Â
StealthChop(quiet):YesÂ
SpreadCyle: YesÂ

Note:1. When choosing SPI working mode, please use soldering iron carefully to prevent scalding hands. When you have finished processing, you should carefully observe whether there is residual tin residue in the module. You must clean it up to prevent it from causing the module to short circuit and burn down.
Â 2.When you connect, please pay attention to the line sequence and IO port. The wrong connection will directly cause the driver to fail to work.
3.When you insert the driver into the motherboard, you should be careful to see the driver direction clearly. And must not insert the driver backwards to prevent the drive from burning.
4.The driver must do a good job of heat dissipation before working (heat sink + cooling fan) to prevent the driver from working abnormally.
Country USA
Brand BEWEE
EAN 0738598959010
Label WITBOT
Manufacturer WITBOT
MPN 4
PartNumber 4
Publisher WITBOT
Studio WITBOT
ReleaseDate 0000-00-00

Country	USA
Brand	BEWEE
EAN	0738598959010
Label	WITBOT
Manufacturer	WITBOT
MPN	4
PartNumber	4
Publisher	WITBOT
Studio	WITBOT
ReleaseDate	0000-00-00

WitBot TMC2130 V1.1 SPI Motor Driver Silent Board with Heat Sink and A Aet Wire for 3D Printer (Pack of 4)

You might also like...