Kapro 227-08 Toolbox Level, 9-Inch
Xmifer stud finder are committed to providing solutions that get reliable and consistent results.Â
1.Feature:
2.How to use Xmifer stud finder?
Step 1: Calibrate the tool before every scan
Placeunit flat on the wall, press power button to power on, press the Scan button(on the right side of the tool) to start calibration. Wait for the reducing bars disappears and beeps to confirm calibration has completed.
Instud/deep mode, put it on the wall where you want to detect to calibrate it ;In AC/Metal mode, put it in the air to calibrate it.
Note:It is important to wait for calibration to complete (2-3 seconds) every time.
Step 2:
Choose the scan model at first, hold down the button, then move the stud finder alongthe wall slowly, The narrow on the screen together with the beep signal alter, guides you to find the location of the stud.
Note:
1.if shake or lift the scanner coincidentally, the device needs to bere-calibrate.
2.ifyou can not scan the object from left to right, please try to scan up and down.
Step 3: Find the location of the stud
When the signal bar is full and the beep alarm is loudest, it means you have found the center of an object. Mark it with your pencil.
Then choose the Metal Scan mode to test whether it is a metal. After you confirm that it is not a metal, it means that you found the center of a stud.
Please note:Â The 9v battery is not included in thepackage.
Country | USA |
Brand | Xmifer |
Manufacturer | Xmifer |
Binding | Misc. |
Color | Black |
Size | Small |
UPCs | 309272583014 |
EANs | 0309272583014 |
ReleaseDate | 0000-00-00 |