Zircon Stud Finder DIY/Pro StudSensor A150 Wall Scanner;

Zircon Stud Finder DIY/Pro StudSensor A150 Wall Scanner; StudScan / DeepScan Modes Detect Edges and Center of Wood / Metal Studs to 1 ½” Alerts Presence of Live, Unshielded AC US Model
- Wire Warning Detection indicates the presence of live, unshielded electrical AC wiring while scanning in StudScan and DeepScan modes
- Target indication bars appear when a stud is detected and increase as the target is approached; the patented spotlite pointing system shines and an audio Tone sounds when the stud center is located
- Ergonomically designed grip allows a comfortable hold on the tool for any size hand, at any angle
- One fully charged 9V battery, not included, is required for the stud scanner to run at optimal performance to help you easily find studs and avoid hazards
The StudSensor A150 is Zirconâ€™s newest center locating electronic stud finder that is sold exclusively on Amazon. The A150 is designed with a smooth, ergonomic rubber grip allowing for a comfortable yet secure hold for any size hand, at any angle. This stud finder uses the most recent technology in density detecting software and circuitry. The scanner has 2 scanning modes to locate the center and edges of wood and metal studs and joists behind walls, floors, and in ceilings up to 1.5 inches (38 mm) deep. In StudScan Mode, the SS A150 locates the center and edges of shallower wood or metal studs up to 0.75 of an inch (19 mm) deep. Switch over to DeepScan Mode to double the scanning depth to 1.5 inches (38 mm). This stud sensor is programmed with a Wire Warning Detection feature that indicates the presence of live unshielded electrical wires up to 2 inches (50 mm) deep when using either stud scanning modes. Finding studs using this center and edge finding tool is simple. To get started, install one brand new 9V alkaline battery (not included). Place the unit flat against the wall and press the Power Button to calibrate the sensor. Once you hear a beep indicating calibration is complete, continue to hold the Power Button and slowly slide the tool across the surface. The Signal Strength Bars will appear on the LCD screen when a stud is detected. As the stud finder detects the edge of a stud, â€œEDGEâ€ will appear in the LCD screen. Continue to slide the tool along the wall until you hear an audio tone and see both the patented arrow-shaped SpotLite Pointer as well as â€œCENTERâ€ on the LCD. These signs indicate the center of the stud has been found. Make sure to note whether the Wire Warning Detection is alerting you to live, unshielded AC wiring before drilling into the center of the stud. With the Zircon StudSensor A150, you can safely maneuver through the most complicated of projects with the professional confidence that comes from owning a Zircon.
Country USA
Brand Zircon
Manufacturer Zircon
Binding Tools & Home Improvement
ItemPartNumber 69332
Model 69332
Warranty 1 Year limited
ReleaseDate 2018-04-02
Size A Series
UnitCount 1
UPCs 042186693324
EANs 0042186693324

Country	USA
Brand	Zircon
Manufacturer	Zircon
Binding	Tools & Home Improvement
ItemPartNumber	69332
Model	69332
Warranty	1 Year limited
ReleaseDate	2018-04-02
Size	A Series
UnitCount	1
UPCs	042186693324
EANs	0042186693324

Zircon Stud Finder DIY/Pro StudSensor A150 Wall Scanner; StudScan / DeepScan Modes Detect Edges and Center of Wood / Metal Studs to 1 ½” Alerts Presence of Live, Unshielded AC US Model

You might also like...