Safely cleans accumulated amounts of varnish, sludge and by-products of combustion
For use in all diesel and gasoline engines
Prepares engine for fresh oil
Protects and extends oil life by 30 percent
Optimizes engine horsepower and performance
Lubegard Engine Flush and Protect Pack is mild enough for engines considered high mileage, and the treatment contains LXE to reduce engine temperatures and minimize friction and wear. Lubegard will save fuel, provide a smoother, quieter and cooler engine and increase engine life. Oil filters can typically remove contaminants up to 25 microns, and that's with a great filter. However, the most dangerous contaminants to your engine are between 5 to 20 microns. These contaminants are larger than the finest tolerances in your engine, but too small for oil filters to remove, causing approximately 60 percent of wear. If these harmful contaminants are not flushed out with a quality flush product, sludge, tar, varnish and wear metals continue to circulate within the engine and accumulate in the passageways, oil pump and oil pan. After an engine is contaminated, regular oil changes do little to restore it's operating efficiency. The detergent and dispersants found in most conventional engine oils can't adequately remove these excessive amounts of contamination. The newly changed oil becomes dirty again within a short period of time, and actually helps to accelerate the formation of even more sludge and varnish. Directions for use with a flush machine: Follow manufacturer's directions. Directions for use without a flush machine: With the engine warm, check for the proper oil level and add new oil if necessary. Add one bottle of Lubegard Engine flush and circulate at idle for 5 to 10 minutes. Stop the engine and drain as usual. Allow sufficient time for the system to drain completely. Install new oil filter and refill with new engine oil in the grade and quality level recommended by the manufacturer. Add the bottle of Lubegard Bio-Tech Engine Oil protectant.