eSUN 3D Printer bio Resin for LCD 3D Printers, 500g eResin-PLA

eSUN 3D Printer bio Resin for LCD 3D Printers, 500g eResin-PLA Red

Product: eSUN PLA Photopolymer Resin for LCD 3D printers, eResin-PLA
Size: 500ml
Color: Red

Packaged in a durable aluminum bottle

Resin parameters:
Solidify wavelength: 395nm to 405nm
Hardness (D): 75D
Viscosity (25C,mPa.s): 250 to 350 mpa.s
Density: 1.10 to 1.11 g / cm3
Shrinkage of Vol.: 5.52%-5.97%

Physical Properties:
Flexural strength (Mpa): 50Mpa to 55Mpa
Flexural Modulus (Mpa): 1.61 to 2.56
Tensile strength (Mpa): 40Mpa to 50 Mpa
Elongation at break (%): 32% to 40%
Notched impact strength (J/m): 90 to 97
Hardness (D): 75D

Precautions:
1. Storage
1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
Avoid any dusty or moist environment.

2. Usage:
1) Shake well before use. Avoid any direct sunlight during usage.
2) Keep it away from the children. Do not put in mouth.
3) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.
4) If accidentally contacted, please wash with plenty of water immediately. Seek medical advice if necessary.
5) Finished models are required to clean by high-concentration alcohol (>95%) about 30 seconds.

Before choosing eSUN resins for your LCD 3D printers, please confirm that the UV wavelength of your 3D printer is 405nm. Thoroughly tested and perfectly compatible to EPAX X1, Anycubic Photon and Wanhao D7.

Bottom Exposure Time: 30-50s when layer thickness is 0.05mm, recommend set to 40s.
Normal Exposure Time: 6-10s when layer thickness is 0.05mm, recommend set to 8s or more.
PS: Exposure time is proportional to layer thickness. The numbers above are for layer thickness 0.05mmã€‚if layer thickness is 0.1mm, the normal exposure time will be 12-20s. If layer thickness is 0.02 then the normal exposure time is 2-4s.
Country USA
Brand eSUN
Manufacturer ESUN
Binding Misc.
ItemPartNumber RESIN-405-PLA-R05
UPCs 840249167634
EANs 0840249167634
ReleaseDate 0000-00-00

Country	USA
Brand	eSUN
Manufacturer	ESUN
Binding	Misc.
ItemPartNumber	RESIN-405-PLA-R05
UPCs	840249167634
EANs	0840249167634
ReleaseDate	0000-00-00

eSUN 3D Printer bio Resin for LCD 3D Printers, 500g eResin-PLA Red

You might also like...